Promontine Finishing Products
Promontine is an adhesive based on plaster intended for the assembly and finishing of partition walls built with gypsum blocks.
Promontine is also used to repair damages and scratches, also to make good joints and imperfections.
| • Standards: |
- European standard EN 12860. |
| |
| •Technical details: |
- Colour: white.
- Substance: powder.
- Retraction (%): not significant.
- Adhesive strength: > 0.5 MPa. |
| |
| • Preparation: |
- Ratio: approximately 25 kg adhesive to 15 litres of water.
- Sprinkle the powder into pure water and let this stand for
approximately 5 minutes.
- After this, mix the powder trough the water either with a
stick manually or using a mixer until a homogeneous
mixture is obtained. Let the adhesive stand for 10 minutes
and stir it again lightly before using it. |
| |
|
• Application:
|
- Apply the adhesive using a spatula or trowel. Ensure the base
is clean, dry and free of dust before applying. |
| |
| • Important Notice: |
- When the adhesive starts hardening, do not try to add water
and mix together the mixture as the glue will have lost its
properties.
|
| |
| • Processing time: |
- Approximately 90 minutes.
- Temperature: Do not use below 5°C.
- Drying time: Approx. 5 hours in normal conditions.
|
| |
| • Storage: |
- Approximately 12 months in the original sealed package.
Store the bags in a way which ensures they are dry and
do not have direct contact with the ground.
|
| |
| • Precautions in use: |
- When preparing try to avoid producing dust when opening
bags or adding powder to the water.
- Contact with skin: wash with pure water.
- Dust in eyes: irrigate immediately and thoroughly with clean
water.
|
|
 |
