Health and Safety
Non Hazardous in normal applications, if contact occurs wash thoroughly with water.
Keep out of reach of children. Contact Euroform Products Ltd for full details.
Storage
Store in cool dry conditions between +5°C and 30°C.
Protect from frost
Shelf Life
Use within 12 months
Limitations
- Not to be used on substrates that might bleed oils, solvents or plasticizers
- Not to be used where joints are constantly immersed in water or as part of a structural
glazing system
- Cold temperatures can extend drying time
- Fully external once cured
Preparation of Surfaces
All surfaces need to be clean, dry and free from dust, grease and other contaminants.
All loose or flaking surface coatings, old sealant and mastic joints should be removed
before application.
Application
Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and
cut at an angle of 450 with an opening slightly larger than the gap to be sealed.
Apply using a standard sealant gun. Best results can be obtained by keeping
an even pressure on the trigger and keeping the gun at a constant angle to
the surface being sealed. To ensure a proper bond, always smooth the
sealant down with a spatula or piece of wood wetted with linseed oil or
white spirits. An improved joint appearance can be achieved by
placing masking tape to both sides of the joint, removing within 5
minutes of application, Single seal joints should be on the fire
rated side of the structure.
